Anycubic Water Wash Resin 2.0 – Grey

Description

Water-washable UV resin | Compatible with 365–405 nm MSLA/LCD printers | Grey finish for detailed prints | Rinse clean with water — no harsh solvents needed

The ANYCUBIC Water Wash Resin 2.0 Grey is designed for MSLA/LCD resin printers and makers who want high-detail results without the hassle of solvent-based cleaning. Its hydrophilic group-modified formulation means printed parts can be rinsed clean with plain water (≥5 minutes), cutting out the need for isopropyl alcohol in the wash stage. Compatible with 365–405 nm UV light sources, it suits a wide range of consumer resin printers. Once washed, a 3-minute post-cure at 405 nm locks in the mechanical properties — tensile strength of 38–43 MPa and hardness of 82–85 HD — delivering finished parts that are firm and dimensionally stable. Best printed in an ambient temperature of 20–40 °C for consistent layer adhesion and reliable results.

Features

• Water-washable formula — rinse printed parts with water (≥5 min), no IPA required during washing
• Compatible with 365–405 nm MSLA/LCD resin printers
• Grey colour for display models, miniatures, and detail-focused prints
• Cured hardness of 82–85 HD with tensile strength of 38–43 MPa
• Low volume shrinkage rate of 2.2–5.5% for dimensionally accurate output
• Post-cure in 3 minutes at 405 nm UV (25,000–30,000 µW/cm²)
• Post-cured resin disposable as standard plastic waste

Specifications

• Colour: Grey (#7E93A7)
• Resin Size: 1kg
• Pre-print preparation: Shake well before use
• Print environment: 20-40 ℃
• First layer exposure duration: 25-40 s
• Normal exposure duration: 2-2.5 s
• Print temperature: 20-50 ℃
• Material: Hydrophilic group-modified light-curing resin
• Wavelength: 365-405 nm
• Viscosity: 190-230/mPa·s(25℃)
• Density: 1.07-1.09/g/cm³
• Hardness: 82-85 HD
• Tensile Strength: 38-43 MPa
• Elongation at Break: 16-22%
• Bending Modulus: 48-60 MPa
• Bending Strength: 2300-3000 MPa
• Young’s Modulus: 1100-1300 MPa
• Izod Impact Strength: 133 J/m
• Volume Shrinkage Rate: 2.2-5.5%
• Cleaning: 95% IPA
• Washing duration: ≥3 mins
• UV Wavelength: 405 nm
• Curing Temperature: 18-30 ℃
• UV Intensity: 25000-30000 uW/cm²
• Curing time: 3 mins
• Disposal: Post-UV-curing resin is treated as plastic waste
• Cleaning: Water
• Washing duration: Medium ≥5 min
• UV Wavelength: 405 nm
• Curing Temperature: 18-30 ℃
• UV Intensity: 25000-30000 uW/cm²
• Curing time: 3 mins
• Disposal:
  • 1. Do not drain wastewater into sewers to avoid contaminating groundwater.
  • 2. After cleaning, let the wastewater sit in the tank for a period of time.
  • 3. Place it under sunlight to allow the resin in the tank to fully cure.
  • 4. Once cured, dispose of it as solid plastic waste for recycling to prevent environmental pollution.

What’s in the Box

• Anycubic Water Wash Resin 2.0 – Grey x1